Baofeng DM-32 --> OpenDM-32

This update appears to have fixed the DCS issue that I reported before.  Thanks!

This update appears to have fixed the DCS issue that I reported before.  Thanks!

Check this version. HotFix

I can't tell any difference between either of the two .bin files above.

The failure to send a DPL tone on transmit problem is fixed.

However, scanning isn't working correctly.  It will not stop on active channels, analog or DMR.  Only for a fraction of a second, and then it moves on.  I tried increasing the scan delay, scan dwell, and scan mode, but it made no difference.

It seems to work fine if you park it on a single channel.

I can't tell any difference between either of the two .bin files above.

I've re-uploaded the file. Check the RX and TX DPL.
http://infotex58.ru/forum/index.php?topic=1168.msg11513#msg11513

I tried the re-uploaded file.

The DPL issue is fixed.

Scanning not working properly.  It won't stop on an active channel.

Does this firmware support analog APRS?  I have it flashed on my DM32 which is working great by the way.  I can't figure out if APRS is working or not.

Does this firmware support analog APRS?

APRS is not working.

Does this firmware support analog APRS?

APRS is not working.

That explains what I was seeing in the radio.  Thanks for all your hard work.  I can confirm that DPL tones are working for transmit and receive.  This was the one feature that I was waiting on getting fixed.  Keep up the great work!!!

I have noticed one thing.  At the end of each transmission the receiving end hears a loud squelch crash where the squelch is held open too long or something.  This is tested on a couple radios on multiple frequencies.  Is this something that can be adjusted in the menu?

Never mind this post.  I just figured out my other radios are doing this I just never noticed this.  This actually seems to be an issue with my Tidradio H8 not with the Dm32 or the OpenDM32 firmware.

thadrumr, is the scan feature on your DM-32 working with this latest firmware?  I find that my radio will scan, but it won't stop on any active transmissions.

thadrumr, is the scan feature on your DM-32 working with this latest firmware?  I find that my radio will scan, but it won't stop on any active transmissions.

I haven't setup the scanning yet.

It seems we are still a long way off a fully working version which I can not see happeing before the end of the year maybe into half of the next year but keep up the work , I will not update my radio until there is a full working version of opendm32

I think theres a lot more improvements to come like the display , aprs , scanning and other bugs to be corrected first before a full working version appears , but good work so far porting this radio.

73 M0MBN

Would it possible to display both the channel name and the frequency on the screen like it has on the stock firmware?

Would it possible to display both the channel name and the frequency on the screen like it has on the stock firmware?

To begin with, we need to get rid of the existing bugs